So… no idea what happened but it works again.

Just in case anyone stumbles upon this thread at some point here are my current settings:

• The compatibility layer is proton-ge-custom (from AUR)
• Steam Input Translation in the Forza Horizon 4 Controller Settings is enabled using the “Official Layout for Forza Horizon 4 - Gamepad”
• Regular mode (not big picture mode)
• Steam Overlay is enabled

I still have the issue that on some screens it shows the keyboard buttons and not the controller buttons but since the controller works anyway I don’t really care (it’s just the optics).

Thanks everyone for your suggestions! :)

Normally regular mode, but I did try big picture with no luck. I also tried Steam overlay on and off. I will try again though all four possibiltues and read up on the GitHub issue thanks!

Any fix?

I only have this one game that I need a controller for

So install back both disks, make a bootable gparted stick and do the cloning from there? The new disk is basically empty save the new file system, but ofc I can just delete that.

I think it’s best to start from scratch since I didn’t lose any data (yet). How would you tackle this move?

Maybe I should start over since I still have the old disk. What would be the best/proper way to swap an older smaller disk for a new larger one?

No UUIDs, only paths. When booting from a live system I noticed /etc/fstab is empty. Also, there where a bunch of partitions on /dev/sda and I can’t see any on /dev/nvme0n1

No not consciously

I’d prefer to keep both the recordings and the transcription local if possible, either on device or self hosted.

OK so I managed to enable it! :) Thanks for everyone suggestions.

If you have the same issue and find this thread later: on a regular install, open /home/yourusername/.config/Nextcloud/nextcloud.cfg with a text editor. On flatpak, open /home/yourusername/.var/app/com.nextcloud.desktopclient.nextcloud/config/Nextcloud/nextcloud.cfg. Add the line showExperimentalOptions=true under the general section. Restart Nextcloud desktop and delete the current synchronization destionation. Readd it and you’ll see the option to use virtual files. Confirm that it’s experimental and you’re done.

I think this is it but I can’t find this option in the settings.

I figured I might have a wrong version or something so I went ahead and grabbed the one off of flathub, but that’s the same one. It syncs everything to one folder on the disk but only until the disk is full. I kinda wanted something like iCloud that would show everthing but only download on demand (so it doesn’t take up all the space).

Maybe I’m using the wrong one? Mine just sits in the task bar and displays the sync status and “helpful” app recommendations. I want to see the files though (in Dolphin for example)…

I did but that’s only syncing one folder if I’m not mistaken. I want to see everything though and if I make changes to files these changes should be synced back to the cloud.

I’ll check it out thanks!

Thanks I’ll try that!

Linux with KDE and MacOS