osaerisxero

Apple is a victim of always having to build the new thing, so there’s never time or resources to fix the old things. They can sometimes do an end run around this by re-releasing the same thing over again and pretending it’s new, but then the cycle just begins anew

Quick, someone post the meme from the Simpsons with a penguin on his face

Flyve’s site says that it’s ceased development, which I found to be slightly amusing since this is the first I’ve heard of it. I have a lot of experience in the MDM space, and to be perfectly frank, for Android your best option is staying first party and sticking with Family Link. The MDM APIs in android land are a hot mess, and have been since their inception, and 3rd party solutions have only ever been adequate at best.

Co-op is generally considered more correct, yes

This is a result of a number of factors more than likely. Root cause is a bad detergent/soap to water ratio, which can be caused by putting too much in or unexpectedly soft water (people who are used to putting hard-water amounts of soap into washing machine loads who suddenly move somewhere with super soft water will often do this once or twice before dialing it back), but a contributing factor here is likely that the drain line that the hose is dumping into is partially clogged, so the suds are having a chance to backflow up past the hose instead of staying with the flow of the water, or the wrong type of soap is used as was mentioned above.

My solution to this was to put the default download folder on an nvme and then move the torrent to a storage hdd after completion

I’m not sure. I never ran into an issue with the boot partition last time I did this, but that was vmware fusion on a macos host in like… 2015 so. So while I would probably just yolo it and unmount the boot partition (or maybe try to migrate/reinstall to another drive so it can have its own boot partition?), you might be better off trying something else.

Either that or try another hypervisor

This is one area where Win11 (and maybe an updated win10?) might have a leg up: my hyper V has the option of adding a disk later in the wizard, which allows me to go into IDE controller 0 and mount a physical disk in the new vm’s settings: